As the house is located in a high-rise residential building, the pressure in that family will be correspondingly low, and sometimes the phenomenon of not coming from the sea will occur. In order not to affect the regular tap water of high-rise residential owners, many high-rise residential residents will install a booster pump at home to deal with this problem. How to install the booster pump? What should we pay attention to when installing booster pump?
How to install the booster pump?
1. Before installation, you should conduct a detailed inspection on each of its components to see if there is a gap connection between its components, if there is any loosening, and if there is any dirt blocking in the flow passage of the pump casing, so as to prevent the situation that cannot be handled during the installation in the middle and later stages. During installation, you need to ensure that it is installed according to the method of verticality or degree. The direction of water flow needs to be consistent with the direction of arrow symbols on the pump casing. The booster pump should be installed as close to the water level as possible.
2. If the situation is approved, the gas booster pump manufacturer proposes that we should raise a gate valve at home. The purpose of doing so is to facilitate future maintenance. In addition, you should also install a constant barometer outside the inlet and outlet of the pump, which can facilitate you to query the application of the lift pump within the scope of consistent rated value and total flow, and this can also reasonably improve the application period of the booster pump.
What are the installation FAQs?
1. The gas booster pump manufacturer believes that during installation, you should follow the appropriate installation sequence and corresponding installation standards. Its installation must be carried out according to the degree or vertical in the notes of "installation method". When the surface of the liposuction solution is smaller than the port on the wind wheel of the booster pump for home use or the shaft winding of the pump, the booster pump for home use shall be installed with a stop valve, and the inlet and outlet ends shall be connected with a tee to serve as a water diversion channel. During one application, the pump shall be filled with water and the screw plug shall be tightened.
2. The connection between the pipelines shall be close without looseness, especially the steam leakage of the water inlet pipeline, which will not only reduce the consistency of the pump or the failure of pumping water. Do not run the booster pump for a long time before water seeps into the chamber to prevent damage to the hydraulic seals. In order to ensure your application safety, it is suggested that you must use the three core multi-function socket with wire connector.
I hope the above can help you. For more relevant information, you can follow our website http://www.9015c.com , contact the professional customer service personnel to explain more and more detailed contents or questions for you, so that you can get some information here!